Licenses of the protocol monitor are not recognized

Licenses of the protocol monitor are not recognized (Chinese)

Under Windows 10 it can happen that the licenses of a connected CAN-Bus Tester 2 are not recognized correctly as long as the language of the operating system is set to Chinese. The respective window shows “No license available” in the status bar.

By changing the language of the operating system to English, the problem could be solved, and the measurements could be performed.

Licenses of the protocol monitor are not recognized (Chinese)

Back to FAQ overview

FAQ about the CAN-Bus Tester 2

50/60 Hz ripple when the tester is connected

Assignment of D‑Sub9 socket on CANtouch and CAN-Bus Tester 2

CAN bus wiring test

CAN Symboleditor Manual

CANBUSview XL III, CAN Quick Tester C‑QT15 and DeviceNet Analyzer

CANopen protocol monitor vs. CANopen bus system

CANtouch vs. CAN-Bus Tester 2, the decision

Common Mode Measurement

Connection between firmware – FPGA – PC software (CBT2 does not measure)

Errorframes: which node sent the message

Exchange service for fieldbus diagnostic devices

How to load a new license file

How to use a file with an additional baud rate

Import of CANtouch trace data

Licenses of the protocol monitor are not recognized

ON-LED flashes yellow, no function, not recognized by PC

Problems with the USB connection at the CBT2

SAE J1939 custom PGN decoding

Send list: move message into sequence

Tester shows non existend error-frames

Trigger DSO with the CBT2

Trigger Output CBT2

Which CANtouch-Firmware fits to which CAN-Bus Tester 2 Software ?


2022/08/15	2022/08/15
Submit a support request

Licen­ses of the pro­to­col moni­tor are not reco­gni­zed (Chi­ne­se)

FAQ about the CAN-Bus Tes­ter 2

Licenses of the protocol monitor are not recognized (Chinese)

FAQ about the CAN-Bus Tester 2