Optimal for permanent monitoring and final inspection
Physical measurement of each message
Reporting of acknowledge errors and error frames
Records up to 10 years
Configurable alarm contact
Access via Ethernet (web interface) and SNMP
Makes predictive maintenance possible
Configuration and
Analysis via
Webinterface
Permanent physical and logical analysis.
Detect difficulties before they can crash the system.
Remote control over Ethernet. Sends an email in case of errors.
If the system stands still, the loss is usually high.
To perform some corrective action at the right time, system components and the whole guidance system should be maintained continually. Because of wear there are worsening of running parameters of the bus system. These changes are diagnosed by our CANobserver within the running system and are notified to the facility operator.
Product |
Description |
GEMAC order number /shoplink |
| CANobserver | CANobserver Bus systems: CAN, CANopen, DeviceNet, SAE J1939 |
PR-22550 – 00 |
Optional Accessories |
||
| PG plug, 9‑pin D‑Sub | Erni, ERBIC CAN node with conduit-thread connector | BU-03050 – 00 on Request |
Spare parts |
||
| Connector for the power supply | Phoenix Contact, MSTB 2.5/3‑STF | X‑03828 – 00 on Request |
| Screw-clamping connector for the error output | Phoenix Contact, MSTB 2.5/2‑ST | X‑03829 – 00 on Request |
For a detailed table with the single measurements of the physical layer diagnosis tools, please have a look at this page.
